hdmi matrix 4x4 switcher with RS-232 control
The 4x4 HDMI Matrix can use four HDMI sources to four HDMI
sinks.The matrix allows four HDMI devices to be switched or split
easily to four HDMI compatible monitors or projectors. The Matrix
can also be placed at the end of a long HDMI cable to regenerate
the HDMI signal.
Four HDMI input signals switched or split to four HDMI sink devices
Support deep color 30bit, 36bit
Support Blue-Ray 24/50/60fs/HD-DVD/xvYCC
Digital audio format, as
Support signal retiming
Support input up to 15metres AWG26 HDMI standard cable length,
output up to 25metres AWG26 cable length
Inputs can be switched with the IR remote control,also can be
controlled by four buttons.
Serial RS-232 remote port
It can smartly jump over those input sources which are not
No loss of quality
lnstalls in minutes
Need DC5V/4A power supply
Operating and Connecting
Connect one cable from each HDMI source devices into HDMI Matrix
Connect one cable from each display (monitor or projector) into the
HDMI Matrix outputs.
Connect 5V power supply to the HDMI 4x4 Matrix.
Alternatively, use an RS-232 control system to switch between
Operating Temperature Range
-5 to +35°C (-41 to +95 °F)
Operating Humidity Range
5 to 90 % RH (no condensation)
Input Video Signal
0.5-1.0 volts p-p
Input DDC Signal
5 volts p-p (TTL)
Video Format Supported
Audio Format Supported
HDMI1.2 and HDMI 1.4
Maximum Transmission Distance
<15m (If needed, HDMI extender is optional)
Mass (Main Unit)
IR receiver cable extender jacks.
When the display device is not near to the matrix, the IR_RX cable
will be too short. There is pair of jacks to extend the IR_RX
cable. Customer or installer can use the headphone cable or 4-line
telephone cable to form the IR cable extender.