Lithium Ion Iron Phosphate Forklift Truck Batteries High Efficient Charging

Lithium Iron Phosphate 6 Volt 24 Volt 36 Volt 48 Volt 80 Volt Forklift Battery

Features

• Lower cost of ownership than AGM lead-acid
• Extremely low weight up to 6 times lower
• Cycle life of 2-15 times higher
• Built-in electronic Battery Management System
• The battery can replace a lead-acid battery without complicated interfaces and software settings
• Very low self-discharge that is 10 - 20 times lower
• Can be charged very fast in 1-3 hours
• Waterproof, corrision resistant
• No service or maintenance needed

SPECIFICATIONS

INTERIOR AND EXTERIOR GALLERY

OTHER RELATED PRODUCT

WARNING

• Replacement of battery shall be performed as per following order. If failed, it may cause fire and explosion. Remove cable from negative terminal first. Connect cable to negative terminal last.
• When connect cable to battery, make sure not to get changed post of +and -. It may cause the damage of electronic components or fire.
• When ueing the battery ,handle with care,sulfuric acid may cause blindness or severe burn.

CAUTION

• When moving battery, be careful not to drop the battery , which is heavy, Do not shake the battery with handle, if there is the handle, It may cause the injury.
• Do not shore the battery at the following places. High temperature and humidity. Being exposed to rain,snow, direct sunshine.

FAQ

1. How to maintain the battery?

• The battery should be stored in clean, dry, ventilated, dark environment when not using, keep it after full charge, and recharge it every 3 months or 6 months.

2. If battery failed, what will be the indications?

• Lower performance
• Low voltage
• Cannot charge/recharge
• Swelled container
• Chemistry corrosion

3. How can you tell if a battery is good or bad?

• You should first check the battery for defects such as a broken circuit, a short, or a broken container. If an outward problem is not apparent, then you will have to check the battery's capacity using known measuring techniques to ascertain the problem.

4. Why "zero voltage" might happen?

Zero voltage means there is a broken circuit. There could be several reasons for a zero voltage state.

• There could be a broken electrode column.
• Welding defects of the partition